Products

    Pages

        CLW-LDIMEX-1GU-W-T

        Single-Channel Wireless Lamp Dimmer, Ground Pin Up, White Textured

        Transform any standard lamp into a fully controllable Crestron® device with the CLW-LDIMEX.

        The CLW-LDIMEX is a plug in dimmer designed to operate as part of a complete Crestron® automation system communicating via the infiNET EX® wireless control network. Without the need for additional control wiring, the CLW-LDIMEX easily acts in place of standard in-wall dimmer or light switch for conventional floor and table lamps.

        infiNET EX

        Ultra-reliable infiNET EX wireless technology provides steadfast two-way RF communications throughout a residential or commercial structure without the need for physical control wiring. Employing a 2.4 GHz mesh network topology, each infiNET EX device functions as an expander, passing command signals through to every other infiNET EX device within range (approximately 150 feet or 46 meters indoors), ensuring that every command reaches its intended destination without disruption[1].

        The CLW-LDIMEX communicates with a Crestron control system via an infiNET EX Wireless Gateway (model CEN-RFGW-EX, DIN-AP3MEX, or MC3[2]). Up to 100 infiNET EX devices may coexist on a single wireless network, and every non-battery-powered device that is added to the network effectively increases the range and stability of the entire network by providing multiple redundant signal paths[1]. Built-in Dynamic Frequency Allocation continuously monitors RF conditions, automatically selecting the clearest channel to prevent interference from neighboring networks, cordless phones, and microwaves.

        Easy Installation

        System design, installation, and upgrades using infiNET EX controlled dimmers could not be easier. Since there's no control wire required, the CLW-LDIMEX can be installed at any outlet and operate like any conventional dimmer.

         
        Key Features
        • Convenient wireless lamp controller
        • Control system integration via infiNET EX® wireless network
        • Plugs into any standard grounded outlet
        • 600 Watt load rating
        • Single- and dual-channel models available
        • Models available for ground pin down and ground pin up outlet configurations
        • CEC Title 24 2013 Compliant
        1. Any infiNET EX device that provides expander functionality will effectively extend the range of the wireless network beyond the initial range of the gateway. Battery-powered infiNET EX devices do not provide expander functionality.
        2. Item(s) sold separately.
        3. Load may be split across both channels in the 2-channel model.

        This product may be purchased from an authorized Crestron dealer. To find a dealer, please contact the Crestron sales representative for your area. A list of sales representatives is available online at www.crestron.com/salesreps or by calling 800-237-2041.

         

        The specific patents that cover Crestron products are listed online at: patents.crestron.com.

         

        Crestron, the Crestron logo, 3-Series, 3-Series Control System, Crestron Green Light, and infiNET EX are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography. Specifications are subject to change without notice. ©2014 Crestron Electronics, Inc.

         
        Pyng
        Load Ratings
          Incandescent/Tungsten Halogen 600 Watts total[3]
          Magnetic Low Voltage 600 VA / 450 Watts total[3]
        Wireless
          RF Transceiver infiNET EX® 2-way RF, 2.4 GHz ISM Channels 11-26 (2400 to 2483.5 MHz), default channel 15; IEEE 802.15.4 compliant
          Range (typical) 150 ft (46 m) indoor, 250 ft (76 m) outdoor to nearest mesh network device(s); subject to site-specific conditions and individual device capabilities[1]
          Gateway Requires an infiNET EX gateway[2]
        Controls and Indicators
          Power/Setup (1) Pushbutton per channel with green LED, for load on/off, dim up/down, and setup
        Connectors
          (1) Grounded AC plug
        Power Requirements
          120 Volts AC, 60 Hz
        Enclosure
          Plastic
        Environmental
          Temperature 32° to 104°F (0° to 40°C)
          Humidity 10% to 90% RH (non-condensing)
        Dimensions
          Height 5.38 in (137 mm)
          Width 3.13 in (80 mm)
          Depth 1.75 in (45 mm)
        Weight
          Single Channel Model 8.3 oz (240 g)
          Dual Channel Model 8.6 oz (250 g)
        Standards & Certifications
          CEC Title 24 2013 Compliant
        1. Any infiNET EX device that provides expander functionality will effectively extend the range of the wireless network beyond the initial range of the gateway. Battery-powered infiNET EX devices do not provide expander functionality.
        2. Item(s) sold separately.
        3. Load may be split across both channels in the 2-channel model.

        This product may be purchased from an authorized Crestron dealer. To find a dealer, please contact the Crestron sales representative for your area. A list of sales representatives is available online at www.crestron.com/salesreps or by calling 800-237-2041.

         

        The specific patents that cover Crestron products are listed online at: patents.crestron.com.

         

        Crestron, the Crestron logo, 3-Series, 3-Series Control System, Crestron Green Light, and infiNET EX are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography. Specifications are subject to change without notice. ©2014 Crestron Electronics, Inc.

        Online Help

        RF/Wireless Best Practices Guide
        Online Help Answer ID :4742