| Video |
| |
Input Signal Types (@TX) |
HDMI w/Deep Color, 3D, & 4K (DVI & Dual-Mode DisplayPort compatible [2]) |
| |
Output Signal Types (@RX) |
HDMI w/Deep Color, 3D, & 4K (DVI compatible [2]) |
| |
Maximum Resolutions |
| |
Scan
Type |
Resolution |
Frame
Rate |
Color
Sampling |
Color
Depth |
| Progressive |
4096x2160 DCI 4K
&
3840x2160 4K UHD |
24 Hz |
4:4:4 |
30 bit |
| 30 Hz |
4:4:4 |
24 bit |
| 30 Hz |
4:2:2 |
36 bit |
| 60 Hz |
4:2:0 |
24 bit |
| 2560x1600 WQXGA |
60 Hz |
4:4:4 |
36 bit |
| 1920x1080 HD 1080p |
60 Hz |
4:4:4 |
36 bit |
| Interlaced |
1920x1080 HD 1080i |
30 Hz |
4:4:4 |
36 bit |
|
| |
NOTE: Common resolutions are shown; other custom resolutions are supported at pixel clock rates up to 300 MHz |
| Audio |
| |
Input Signal Types (@TX) |
HDMI (Dual-Mode DisplayPort compatible), analog stereo [3] |
| |
Output Signal Types (@RX) |
HDMI, analog stereo [4] |
| |
Digital Formats |
Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS®, DTS-ES, DTS 96/24, DTS-HD High Res, DTS-HD Master Audio, LPCM up to 8 channels |
| |
Analog Formats |
Stereo 2-channel |
| |
Analog-To-Digital Conversion |
24-bit 48 kHz |
| |
Digital-To-Analog Conversion |
24-bit 48 kHz |
| |
Analog Performance |
Frequency Response: 20 Hz to 20 kHz ±0.5 dB;
S/N Ratio: >95 dB, 20 Hz to 20 kHz A-weighted;
THD+N: <0.005% @ 1 kHz;
Stereo Separation: >80 dB, 20 Hz to 20 kHz |
| Communications |
| |
Ethernet |
10/100 Mbps pass-through |
| |
USB |
USB 2.0 pass-through (also supports firmware update via USB mass storage device at TX) |
| |
RS-232 |
2-way serial pass-through up to 115.2k baud (TD/RD only) |
| |
IR |
Bidirectional IR signal pass-through up to 60 kHz |
| |
HDMI |
HDCP 2.2, EDID, CEC pass-through |
| |
HDBaseT |
HDCP 2.2, EDID, PoE+, Ethernet, IR/RS-232 (intended for signal extension between TX & RX only) |
| Connectors – Transmitter (HD-TX-USB-2000-C) |
| |
HDMI IN |
(1) HDMI Type A connector, female;
HDMI digital video/audio input;
(DVI & Dual-Mode DisplayPort compatible [2]) |
| |
AUDIO IN |
(1) 3.5 mm TRS mini phone jack & (1) 5-pin 3.5 mm detachable terminal block;
Balanced or unbalanced stereo line-level audio input [3];
Maximum Input Level: 4 Vrms balanced, 2 Vrms unbalanced;
Input Impedance: 10k Ohms balanced, 5k Ohms unbalanced;
Note: The TRS jack is unbalanced stereo and paralleled with the L+ (tip), R+ (ring), and ground (sleeve) terminals; only one audio input connection should be used; this input signal supplants the HDMI audio input signal when selected |
| |
USB (host) |
(1) USB Type A connector, female;
USB 2.0 host port for connection of a mouse, keyboard, or any other USB 2.0 peripheral device [5];
Passes USB data to/from the USB device port on the RX when in DEVICE mode;
Available Power: 1 Amp at 5 Volts DC |
| |
USB (device) |
(1) USB Type Micro-B connector, female;
USB 2.0 device port for connection to a computer or any other USB 2.0 host [5];
Passes USB data to/from the USB host port on the RX when in HOST mode |
| |
LAN |
(1) 8-pin RJ45 connector, female;
10Base-T/100Base-TX Ethernet port;
Passes Ethernet data to/from the LAN port on the RX |
| |
COM |
(1) 3.5 mm TRS mini phone jack & (1) 3-pin 3.5 mm detachable terminal block;
Bidirectional RS-232 port;
Passes RS-232 TD/RD data to/from the COM port on the RX;
Supports up to 115.2k baud
Note: The TRS jack and terminal block are paralleled; only one should be used |
| |
IR IN |
(1) 3.5 mm TS mini phone jack & (1) 2-pin 3.5 mm detachable terminal block;
IR input port for connection from a Crestron IR control port or other IR signal source;
Passes IR signal to the IR OUT port on the RX;
Supports IR up to 60 kHz;
Note: The TS jack and terminal block are paralleled; only one should be used |
| |
HDBT OUT |
(1) 8-pin RJ45 connector, female, shielded;
HDBaseT and PoE Class 3 PD port for connection to the HDBT IN port on the RX [1] |
| |
IR OUT |
(1) 3.5 mm TS mini phone jack & (1) 2-pin 3.5 mm detachable terminal block;
IR output port for connection to an IR emitter;
Passes IR signal from the IR IN port on the RX;
Supports IR up to 60 kHz;
Note: The TS jack and terminal block are paralleled; only one should be used |
| Connectors – Receiver (HD-RX-USB-2000-C) |
| |
HDMI OUT |
(1) HDMI Type A connector, female;
HDMI digital video/audio output (DVI compatible [2]) |
| |
AUDIO OUT |
(1) 3.5 mm TRS mini phone jack & (1) 5-pin 3.5 mm detachable terminal block;
Balanced or unbalanced stereo line-level audio output [4];
Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced;
Output Impedance: 499 Ohms balanced or unbalanced;
Note: The TRS jack is unbalanced stereo and paralleled with the L+ (tip), R+ (ring), and ground (sleeve) terminals |
| |
USB (host) |
(1) USB Type A connector, female;
USB 2.0 host port for connection of a mouse, keyboard, or any other USB 2.0 peripheral device [5];
Passes USB data to/from the USB device port on the TX when in HOST mode;
Available Power: 1 Amp at 5 Volts DC |
| |
USB (device) |
(1) USB Type Micro-B connector, female;
USB 2.0 device port for connection to a computer or any other USB 2.0 host [5];
Passes USB data to/from the USB host port on the TX when in DEVICE mode |
| |
LAN |
(1) 8-pin RJ45 connector, female;
10Base-T/100Base-TX Ethernet port;
Passes Ethernet data to/from the LAN port on the TX |
| |
COM |
(1) 3.5 mm TRS mini phone jack & (1) 3-pin 3.5 mm detachable terminal block;
Bidirectional RS-232 port;
Passes RS-232 TD/RD data to/from the COM port on the TX;
Supports up to 115.2k baud;
Note: The TRS jack and terminal block are paralleled; only one should be used |
| |
IR IN |
(1) 3.5 mm TS mini phone jack & (1) 2-pin 3.5 mm detachable terminal block;
IR input port for connection from a Crestron IR control port or other IR signal source;
Passes IR signal to the IR OUT port on the TX;
Supports IR up to 60 kHz;
Note: The TS jack and terminal block are paralleled; only one should be used |
| |
HDBT IN |
(1) 8-pin RJ45 connector, female, shielded;
HDBaseT and PoE+ PSE port for connection to the HDBT OUT port on the TX [1] |
| |
IR OUT |
(1) 3.5 mm TS mini phone jack & (1) 2-pin 3.5 mm detachable terminal block;
IR output port for connection to an IR emitter;
Passes IR signal from the IR IN port on the TX;
Supports IR up to 60 kHz;
Note: The TS jack and terminal block are paralleled; only one should be used |
| |
24VDC 1.25A |
(1) 2.1 x 5.5 mm DC power connector;
24 Volt DC power input;
PW-2412WU power pack included;
Note: This connection powers both the receiver and transmitter |
| Controls & Indicators – Transmitter (HD-TX-USB-2000-C) |
| |
POWER |
(1) Bi-color green/amber LED, indicates operating power is supplied via the HDBaseT link to the companion receiver, turns amber while booting and green when operating |
| |
HDMI IN |
(1) Green LED, indicates HDMI input signal presence |
| |
LINK |
(1) Bi-color green/amber LED, green indicates an HDBaseT link with video, amber indicates a link without video |
| |
AUDIO SEL HDMI/ANALOG |
(1) 2-position slide switch, selects the audio input [3] |
| |
RESET |
(1) Recessed pushbutton, initiates hardware reset of both the transmitter and receiver |
| |
LAN |
(2) LEDs, green LED indicates Ethernet link status, amber LED indicates Ethernet activity |
| |
HDBT OUT |
(2) LEDs, amber LED indicates HDBaseT link status, green LED indicates PoE |
| Controls & Indicators – Receiver (HD-RX-USB-2000-C) |
| |
POWER |
(1) Bi-color green/amber LED, indicates operating power is supplied from the power pack via the 24VDC input, turns amber while booting and green when operating |
| |
HDMI OUT |
(1) Green LED, indicates HDMI output signal presence |
| |
LINK |
(1) Bi-color green/amber LED, green indicates an HDBaseT link with video, amber indicates a link without video |
| |
HOST/AUTO/DEVICE |
(1) 3-position slide switch, selects the USB mode [5] |
| |
LAN |
(2) LEDs, green LED indicates Ethernet link status, amber LED indicates Ethernet activity |
| |
HDBT IN |
(2) LEDs, amber LED indicates HDBaseT link status, green LED indicates PoE |
| Power |
| |
Power Pack (included) |
Input: 0.8 Amps (maximum) @ 100-240 Volts AC, 50/60 Hz;
Output: 1.25 Amps @ 24 Volts DC;
Model: PW-2412WU |
| |
Power Consumption |
18.7 Watts typical |
| Environmental |
| |
Temperature |
32° to 104° F (0° to 40° C) |
| |
Humidity |
20% to 90% RH (non-condensing) |
| |
Heat Dissipation |
63.8 BTU/hr |
| Construction – Typical of Transmitter & Receiver |
| |
Chassis |
Metal, black finish, with (2) integral mounting flanges, vented sides |
| |
Mounting |
Freestanding, surface mount, or attach to a single rack rail |
| Dimensions |
| |
Transmitter
(HD-TX-USB-2000-C) |
Height: 4.47 in (114 mm);
Width: 9.61 in (244 mm);
Depth: 0.99 in (25 mm) |
| |
Receiver
(HD-RX-USB-2000-C) |
Height: 4.47 in (114 mm);
Width: 9.61 in (244 mm);
Depth: 0.99 in (25 mm) |
| Weight |
| |
Transmitter
(HD-TX-USB-2000-C) |
1.71 lb (776 g) |
| |
Receiver
(HD-RX-USB-2000-C) |
1.71 lb (776 g) |
| Maximum HDBaseT Cable Lengths |
| |
Resolution |
Cable Type |
DM-CBL-ULTRA
DigitalMedia™ Ultra Cable |
DM-CBL-8G
DigitalMedia 8G™ Cable |
CAT5e
(or better) [1] |
| 1080p60 Full HD |
330 ft (100 m) |
330 ft (100 m) |
330 ft (100 m) |
| 1920x1200 WUXGA |
| 1600x1200 UXGA |
| 2048x1080 DCI 2K |
| 2560x1440 WQHD |
230 ft (70 m) |
165 ft (50 m) |
| 2560x1600 WQXGA |
| 3840x2160 4K UHD |
| 4096x2160 DCI 4K |
|
